Microfoongalgen König & Meyer 23840-300-55 staal zwart 46-96 cm

Flexible desktop microphone boom arm with 3/8" or 5/8" threaded connection for recording studios and multimedia workstations. The boom arm supports microphones, tablets or smartphones with a total weight up to 0.8 kg and offers a height adjustment range from 46 cm to 96 cm. The steel construction with plastic inserts and non-slip support provides stable clamping and positioning. The product is supplied without cable and includes four cable clips for neat cable routing. The clamp fits desks and tubes with a clamping range from 10 to 51 mm (ø 15 to ø 51 mm) and can optionally be fixed using a separately available table flange.

Advantages

The steel boom pole combines low weight with structural strength, allowing precise height adjustment while remaining easy to handle. Its dual threaded connections (3/8" and 5/8") ensure compatibility with a wide range of microphones and mounts. The clamp design with shaped clamping surfaces and non-slip support secures the arm on flat surfaces and round tubes. Four cable clips are included to keep cables tidy, and the absence of pre-fitted cable gives flexibility to choose preferred cabling.

Suitable for

• Recording studio microphones
• Podcast and streaming setups
• Multimedia workstations with tablets or smartphones (up to 0.8 kg)
• Home office voice recording and conferencing

Key specifications

• Material: steel with plastic inserts
• Height adjustment range: 46–96 cm
• Maximum load: 0.8 kg
• Threaded connections: 3/8" and 5/8"
• Clamp clamping range: 10–51 mm (ø 15–ø 51 mm)
• Weight: approx. 800 g
• Includes: four cable clips; delivered without cable

How to use

Attach the clamp securely to a desk edge or suitable tube within the specified clamping range. Insert the boom arm and set the desired height between 46 and 96 cm, then mount a microphone or device using the 3/8" or 5/8" thread. Route cables along the arm and secure them with the supplied clips. Adjust the arm position and tighten the joints to achieve the required alignment.

Recommendations

For stable operation, ensure the clamp is mounted on a surface or tube within the specified diameters and that the total payload does not exceed 0.8 kg. If you require a permanent or through-table installation, consider using the separately available table flange.