RUKO FRS-M 10,0 mm wolfraamcarbide dubbelvertanding spitskegel rotatiefrees

The RUKO FRS-M 10.0 mm conical point burr stands out with its double-cut (cross-cut) tooth geometry, which delivers a noticeably smoother finish and better control on hard materials compared to single-cut burrs. Its tungsten carbide head keeps its edge far longer than HSS alternatives when working on tough steels and cast iron.

Highlights

• Precision-ground tungsten carbide head for long service life
• Double-cut (cross-cut) teeth for reduced vibration and fine surface finish
• 10.0 mm head diameter, 6 mm shank fits standard collets
• Conical point shape reaches into tight angles and corners
• For use on steel, cast steel, stainless steel, non-ferrous metals and cast iron

In daily use

This burr is a dependable choice for deburring, edge breaking, weld preparation and surface finishing. It runs best in straight grinders, flexible shaft drives or robots at 10,000–20,000 RPM depending on the material, with a maximum permissible speed of 25,000 RPM. The 65 mm overall length and 20 mm head length give good reach without excessive overhang.

Full specifications

• Tool type: Rotary burr
• Head shape: Conical point (Spitzkegel)
• Cut type: Double cut (cross-cut)
• Head diameter (D1): 10.0 mm
• Head length (L2): 20 mm
• Shank diameter (D2): 6 mm
• Overall length (L1): 65 mm
• Tool material: Tungsten carbide (VHM)
• Material compatibility: Steel, cast steel, stainless steel (INOX), non-ferrous metals, cast iron, high-temperature materials
• Recommended RPM range: 10,000–20,000 RPM
• Max. permissible speed: 25,000 RPM
• Applications: Deburring, edge breaking, trimming, weld preparation, surface finishing, chamfering
• Drive type: Straight grinders, flexible shaft drives, robot applications, machine tools
• Standard: DIN 8032
• Series: PFERD FRS-M

Final note

A workhorse burr for metalworking professionals who need consistent cutting performance and a fine finish in hard-to-reach areas.