UN BESSEY D49-2 rechtsschaar, RVS-messen, 165 mm

UN BESSEY D49-2 straight snips, 165 mm long, feature stainless steel blades and an ergonomic handle designed to reduce hand fatigue. The snips are built for precise, straight cuts on multicore cables up to 10 mm in diameter, as well as for trimming wire, sheet materials and small components in workshop, electrical and maintenance tasks.

Advantages

The stainless steel blades provide corrosion resistance and maintain a sharp cutting edge for accurate, repeatable cuts. The ERGO-handle improves comfort during extended use and helps reduce hand strain. Their straight blade profile and balanced feel allow controlled trimming and finishing work.

Suitable for

• Cutting multicore cables and small-diameter power or signal wires (up to 10 mm diameter)
• Trimming sheet material, thin metal strips and small components
• Electrical installation, workshop tasks and general maintenance

When it may not be suitable

These straight snips are intended for precise trimming and small cutting tasks; they are not designed for heavy-duty cutting of large-gauge cable, thick rod, or hardened materials. For tasks requiring greater cutting force or larger capacity, a dedicated heavy-duty cutter or bolt cutter is more appropriate.

Key specifications

• Overall length: 165 mm
• Blade material: stainless steel
• Handle type: ergonomic (ERGO) handle for reduced hand fatigue
• Maximum recommended cable diameter: up to 10 mm (multicore cables)
• Blade form: straight cutting profile

How to use

Position the straight blades around the cable or material to be cut so the cutting edge meets the workpiece at the intended point. Apply steady, even pressure on the handles until the blades close completely and sever the material. For cleaner cuts on thin sheet or wire, make sure the blades are aligned and the material is supported. After use, wipe the blades clean and store the snips in a dry place to maintain blade condition.

What to consider before purchase

• Intended cutting tasks and maximum material diameter (suitable up to 10 mm cables)
• Need for corrosion-resistant blades for use in humid or corrosive environments
• Comfort and ergonomics for extended use
• Whether a heavier-duty cutter is required for thicker or harder materials

Recommendations

Use the snips for precise, straight cuts on cables, wire and thin sheet; avoid cutting hardened wire, large-gauge conductors or materials exceeding the recommended diameter to prolong blade life and maintain cutting performance.