10GBASE-SR-XFP-BO netwerk-transceivermodule BlueOptics glasvezel XFP LC

The BlueOptics 10GBASE-SR-XFP-BO is a compatible 10GBASE-SR XFP fiber optic transceiver module with an XFP interface and LC duplex connector. It transmits and receives optical signals at 850 nm over multi-mode fiber and supports data rates up to 10 Gbit/s with a typical reach of up to 300 meters. The module is designed as a drop-in replacement for original Extreme Networks 10GBASE-SR XFP modules and is manufactured to MSA standards to ensure physical and protocol compatibility with supported network hardware.

Advantages

The BlueOptics 10GBASE-SR-XFP-BO offers tested compatibility with major Extreme Networks platforms while meeting software and hardware requirements. It uses high-quality components such as proven lasers and integrated circuits, resulting in long operational life and high availability. The module supports Digital Diagnostics (DDM/DOM) for real-time monitoring of voltage, laser bias current, transmit and receive power, and temperature, which simplifies maintenance and troubleshooting.

Suitable for

• 10 Gbit/s Ethernet links over multimode fiber (up to ~300 m)
• Fibre Channel over Ethernet (FCoE) and SDH/SONET applications at 10G
• Switches, routers, storage systems and other network equipment supporting XFP SR transceivers

Key specifications

• Form factor: XFP
• Wavelength: 850 nm (Tx/Rx)
• Connector: LC duplex
• Maximum data rate: 10 Gbit/s
• Typical reach: up to 300 m on multimode fiber
• Interface type: XFP
• Weight: 0.02 kg
• Product colour: Aluminium
• Manufacturer part number (MPN): 10GBASE-SR-XFP-BO
• EAN: 4063232631271

How to use

Install the 10GBASE-SR-XFP-BO module into an available XFP slot on a compatible switch, router or storage device according to the host device instructions. Connect LC duplex multimode fiber patch cords to the transceiver ports, ensuring correct Tx-to-Rx alignment. Verify that the host hardware firmware or software recognises third-party modules and enable DDM/DOM support in the host if remote diagnostics are required. Perform link tests and monitor the diagnostic values after installation to confirm correct operation.

Recommendations

For best performance and maximum range, use high-quality BlueOptics multimode fiber patch cords and patch panels. Ensure the host device supports DDM/DOM to access digital diagnostics. Follow ESD precautions during installation and avoid bending the fiber beyond recommended radii to maintain link integrity.