2-power 2P-H000037930 - beeldscherm - 39,6 cm (15,6) - WXGA

When a laptop screen cracks or its backlight dims, a technician reaches for a replacement panel that matches the original's connector and resolution. The 2-Power 2P-H000037930 is that panel: a 15.6-inch WXGA display built around a 40-pin LVDS interface, the standard for countless notebooks from the last decade. It restores a bright, crisp image without hunting for proprietary parts.

Key specifications

• Screen size: 15.6 inches (39.6 cm) diagonal
• Native resolution: 1366 x 768 pixels (WXGA)
• Aspect ratio: 16:9 widescreen
• Panel technology: TN (Twisted Nematic) TFT active matrix LCD
• Backlight: LED, providing even illumination
• Surface finish: Glossy, for vivid colours
• Connector: 40-pin LVDS, bottom-left position when viewed from the back
• Refresh rate: 60 Hz
• Colour support: 262,144 colours (6-bit)
• Pixel density: approximately 100 PPI
• Condition: New, compatible with laptops requiring a 15.6" WXGA LED panel with 40-pin LVDS

Why choose it

This panel matches the exact electrical and mechanical footprint of the original 2-Power part, so installation is straightforward for any experienced technician. The LED backlight consumes less power and lasts longer than older CCFL tubes, while the glossy finish enhances contrast for everyday tasks. With a 60 Hz refresh rate and 6-bit colour depth, it handles office work, web browsing, and video playback without flicker or banding.

Ideal use cases

• Replacing a damaged or faulty 15.6-inch WXGA screen in a laptop
• Upgrading a compatible notebook from a lower-resolution or CCFL-backlit panel
• Refurbishing used laptops for resale or donation
• Repairing a laptop with a broken LVDS connector or dead pixels

Good to know

The 40-pin LVDS connector is positioned on the bottom left when viewing the panel from the back, so verify your laptop's cable orientation before ordering. Because this is a TN panel, viewing angles are narrower than IPS, but it delivers fast response times and lower cost. Always handle the panel by its edges and use an anti-static wrist strap during installation to avoid damage.