2-power 2P-KVR13N9S8H/4 - 4 GB - 1 x 4 GB - DDR3 - 1333 MHz

For desktop users upgrading an older system, the 2-POWER 2P-KVR13N9S8H/4 delivers a straightforward 4GB boost. This single DDR3 module runs at 1333MHz, matching the needs of many Intel and AMD platforms from the DDR3 era. It fits standard 240-pin DIMM slots and operates at the standard 1.5V, so it drops into most desktops without BIOS tweaks.

Key specifications

• Capacity: 4GB (1 x 4GB module)
• Memory type: DDR3 SDRAM
• Speed: 1333MHz (PC3-10600)
• CAS latency: CL9
• Form factor: 240-pin DIMM
• Error correction: Non-ECC
• Buffering: Unbuffered
• Voltage: 1.5V
• Rank: Single rank
• Intended use: Desktop PC

Why choose it

This module is a reliable replacement or upgrade for aging desktops. It uses industry-standard specifications, so compatibility is broad across DDR3 systems. The single-rank design can be easier on memory controllers, and the 1.5V operating voltage aligns with JEDEC standards, helping to keep power consumption and heat in check.

Ideal use cases

• Upgrading an older desktop from 2GB or 4GB to 8GB total (with two modules)
• Replacing a failed 4GB DDR3 DIMM in a business PC
• Building or refreshing a budget home office computer
• Adding memory to a small form factor desktop that accepts full-height DIMMs

Good to know

Before ordering, confirm your motherboard supports DDR3 1333MHz and has an available 240-pin DIMM slot. This module is not suitable for laptops (which use SO-DIMM) or servers requiring ECC memory. For best results, install in pairs to enable dual-channel mode if your board supports it.