3D-printmateriaal Creality 3D 3301010309 polymelkzuur PLA rood 1 kg 1,75 mm

Creality 3D 3301010309 Polylactic acid (PLA) Red 1 kg 1.75 mm is a ready-to-use thermoplastic filament designed for FDM/FFF 3D printers. Supplied on a 1 kg spool with a consistent 1.75 mm diameter, this red PLA is formulated to provide reliable extrusion, good layer adhesion and fine surface detail. The material is compatible with Creality 3D printers and other machines that accept 1.75 mm PLA, and it is suitable for a wide range of prototypes, models and finished parts where dimensional stability and visual appearance are important.

Advantages

This PLA filament offers straightforward printing characteristics with low warping and minimal odor during extrusion. Its uniform diameter and controlled tolerance support stable feed and reduced clogging risks on setups calibrated for 1.75 mm filament. The pigment provides consistent red colour across prints and helps achieve good layer definition and surface finish without special printing surfaces or enclosures.

Suitable for

• Prototyping and concept models
• Decorative objects and figurines
• Functional parts with moderate mechanical demands
• Educational projects and hobbyist printing

Key specifications

• Material: Polylactic acid (PLA)
• Filament diameter: 1.75 mm
• Spool weight: 1 kg
• Colour: Red
• Recommended use: FDM/FFF 3D printing

How to use

Load the 1.75 mm filament into the printer following the manufacturer’s filament loading procedure and set extrusion temperature according to your printer and nozzle type. Typical nozzle temperatures for PLA are in the lower-medium range; adjust print speed and temperature for layer adhesion and surface quality. Ensure the print bed is prepared—use blue tape, glue stick or a heated bed at low temperature if required—and calibrate the first layer for correct adhesion. Monitor initial layers to confirm steady flow and make fine adjustments to retraction and cooling settings as needed.

Recommendations

Store the spool in a dry environment and keep it sealed with desiccant when not in use to prevent moisture absorption. For best results, print at moderate speeds with active part cooling and keep retraction settings conservative to avoid oozing. If stronger mechanical properties are required, consider post-processing options such as annealing where suitable for PLA-based parts.