AOC CBO SFP28 BlueOptics BO272703Q50M 50 m actieve optische kabel

AOC CBO SFP28 BlueOptics BO272703Q50M 50 m active optical cable is a factory-terminated, fixed-length fiber interconnect designed for 25 Gb/s SFP28 ports. The cable integrates optical transceivers into a lightweight, armored assembly that plugs directly into SFP28 cages, delivering a single-cable solution for server-to-switch and switch-to-switch connections. With a 50 meter reach, the AOC removes the need for separate transceivers and patch cords, simplifies cabling, reduces rack congestion and supports high-density deployment in data centers and enterprise networks.

Advantages

This active optical cable provides native compatibility with SFP28 interfaces and supports full 25 Gigabit Ethernet line rates over a 50 m distance. Its integrated design lowers link latency and eliminates additional fiber patching, while the thin-profile cable and secure connector ends help save space in densely populated racks. The factory-terminated construction ensures consistent optical performance and reduces installation time compared to discrete transceiver plus patch-cable assemblies.

Suitable for

• Server-to-switch 25 Gb/s connections within racks or between adjacent aisles
• Switch-to-switch aggregation or leaf-spine links in data center topologies
• High-density network deployments where cable-management and space savings are priorities
• Environments requiring simplified optical links without separate transceivers and patch cords

Key specifications

• Connector type: SFP28 to SFP28 active optical assembly
• Nominal data rate: 25 Gb/s per link
• Length: 50 meters fixed
• Medium: single-mode optical with integrated active electronics
• Interface: hot-pluggable SFP28 form factor
• Typical use: short-range data center interconnects and enterprise backbone links

How to use

Install the active optical cable by inserting each SFP28 connector into the corresponding device port until the latch engages. Ensure both devices are powered and configured for 25 Gb/s operation and verify link status through network management systems or device LEDs. No separate transceivers or fiber patch cords are required. For removal, release the connector latch and pull straight out to avoid stressing the cable assembly. Handle the cable by the connector housings rather than bending the cable sharply near the terminations.

Recommendations

Use the cable within its specified 50 m range and avoid tight bends or compressive force on the cable jacket. Deploy in rack pathways or cable trays that support high-density routing and maintain manufacturer-recommended bend radius. Confirm device compatibility with SFP28 AOC assemblies before installation and monitor link parameters after deployment to ensure stable 25 Gb/s operation.