AOC SFP28 BlueOptics BO272703Q30M 30M actieve optische kabel, CBO

Active optical cable AOC SFP28 BlueOptics BO272703Q30M 30M by BlueOptics (CBO) is a factory-terminated fiber solution for SFP28 interfaces. Engineered for 25GbE networks and compatible high-speed links, this 30-meter AOC provides a fixed optical connection that eliminates the need for separate transceivers and patch cables. The cable is intended for short to mid-range interconnects inside data centers and server rooms where low latency, low electromagnetic interference and predictable signal integrity are required.

Advantages

The active optical construction reduces sensitivity to electromagnetic interference and crosstalk compared with copper alternatives, while maintaining low latency suitable for high-performance switching and server interconnects. As a factory-terminated, plug-and-play SFP28 assembly, it simplifies deployment, reduces component count and ensures consistent optical performance over the full 30 m length. The cable’s lightweight and flexible design eases routing in dense rack environments and minimizes stress on ports.

Suitable for

• 25GbE switch-to-switch and switch-to-server connections
• Data center top-of-rack and end-of-row interconnects
• Server clusters and high-performance computing links
• Environments requiring reduced electromagnetic interference

Key specifications

• Interface type: SFP28 active optical cable
• Cable length: 30 meters
• Data rate support: 25 Gbps per lane (suitable for 25GbE)
• Connector style: factory-terminated SFP28 plugs (both ends)
• Construction: active optical fiber with integrated transceivers and electronics
• Physical characteristics: lightweight, flexible fiber assembly for rack routing
• Typical applications: short- to mid-reach intra-data center links

How to use

Install each SFP28 plug into the corresponding SFP28 port on the networking devices until the connector latches. Verify link status through device LEDs or management interfaces to confirm proper negotiation at 25GbE where supported. No separate transceivers or patch fiber are required; handle the cable by the connectors and avoid sharp bends or excessive pulling on the fiber jacket to maintain optical performance. When removing, press the connector latch and withdraw straight out to prevent damage to the port.

Recommendations

For reliable operation, route the cable with a bend radius that meets the manufacturer’s fiber handling guidelines and avoid tight bends or crushing. Use proper ESD precautions when handling optical assemblies and ensure both ends are clean before insertion to prevent signal degradation. Verify device compatibility with SFP28 AOC modules and confirm firmware or hardware support for fixed-rate 25GbE links where necessary.