BlueOptics 10G-SFP-SR-SA netwerk-transceivermodule 10000 Mbit/s SFP+ 850 nm

The BlueOptics 10G-SFP-SR-SA is an SFP+ multimode fiber transceiver module engineered for 10 Gbit/s Ethernet and similar high-speed links. Operating at an 850 nm wavelength, this compact silver module supports short-range optical connections over multimode fiber using an LC duplex interface. Weighing approximately 20 g and conforming to SFP+ form-factor specifications, it is suitable for use in switches, routers, storage systems and other network hardware that accept SFP+ modules.

Advantages

The module offers 10,000 Mbit/s maximum data throughput with a standardized SFP+ interface for plug-and-play installation in compatible ports. Its 850 nm optical design is optimized for short-range multimode fiber runs, providing predictable link characteristics and reduced susceptibility to electromagnetic interference compared with copper cabling. The small, lightweight metal housing facilitates handling and mounting while meeting industry mechanical and electrical conventions for SFP+ transceivers.

Suitable for

• 10 Gbit/s Ethernet aggregation and access links over multimode fiber
• Short-range connections within data centers, server rooms or wiring closets
• Interconnection between switches, routers and storage devices supporting SFP+
• Environments where low-latency, EMI-resistant optical links are required

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10,000 Mbit/s (10 Gbit/s)
• Wavelength: 850 nm (multimode fiber)
• Connector: LC duplex
• Typical application range: short-range multimode links (SR)
• Color and housing: silver, compact metal SFP+ form factor
• Weight: ~0.02 kg

How to use

Install the BlueOptics 10G-SFP-SR-SA into an available SFP+ port until it seats securely, following the host device vendor's hot-swap and electrostatic discharge guidelines. Connect an appropriate LC duplex multimode fiber patch cable at both ends, ensuring correct fiber type and polishing/connector quality for SR links. Verify link status and speed in the host device management interface and confirm any required settings such as auto-negotiation or fixed speed are configured according to network design.

Recommendations

Use OM3/OM4 multimode fiber for optimal short-range 10 Gbit/s performance, keep connector endfaces clean, and confirm that the host device supports SFP+ transceivers with the specified optical parameters. For remote diagnostics, enable and consult any available digital diagnostic monitoring (DDM/DOM) features on supported hardware to monitor optical power and temperature.