Actieve optische kabel (AOC) CBO SFP28-AOC-10M 10 m SFP28 SFP28-AOC-10M-MA-BO

CBO SFP28-AOC-10M is a 10-meter Active Optical Cable (AOC) with SFP28 connectivity engineered for 25Gb/s class links. The integrated optical transceivers are built into the cable assembly, enabling a direct optical connection between SFP28 ports on switches, servers or NICs without separate pluggable modules. This AOC is intended for short-reach high-speed interconnects in data center and enterprise environments where reduced power consumption and compact cabling are required.

Advantages

The Active Optical Cable offers lower power consumption compared with equivalent electrical direct attach copper solutions and removes the need to manage separate transceivers. Its optical construction provides electrical isolation and reduced electromagnetic interference, while the fixed-length assembly simplifies deployment and rack planning. The 10 m length enables flexible placement of equipment within the same room or adjacent racks without sacrificing signal integrity for 25Gb/s class links.

Suitable for

• Server-to-switch and switch-to-switch interconnects within racks and across adjacent racks
• High-speed uplinks and leaf-spine fabrics operating at 25Gb/s class rates
• Network interface cards (NICs) to top-of-rack switch connections
• Environments requiring reduced power draw and compact cabling layouts

Key specifications

• Connector type: SFP28 on both ends (fixed cable assembly)
• Nominal data rate: designed for 25 Gigabit per second class links
• Cable type: active optical cable with integrated transceiver electronics
• Length: 10 meters
• Signal reach: short-reach optical interconnect suitable for data center racks
• Electrical characteristics: reduced power consumption compared to copper DACs
• EMI: optical transmission provides electrical isolation and low electromagnetic interference

How to use

Install the AOC by inserting each SFP28 connector into compatible SFP28 ports on the networking equipment until the latch engages. Ensure that both ends are seated in SFP28-rated ports and that firmware or driver support for active optical assemblies is present on the devices. After insertion, verify link status and speed through the switch or host management interface and adjust port configuration if required. No separate transceiver modules or fiber patch cords are needed.

Recommendations

Route the cable to avoid sharp bends and protect the fiber assembly from mechanical stress. Maintain the minimum bend radius specified by the manufacturer, keep the cable free from tight kinks and avoid running it near high-heat sources. Use proper ESD precautions when handling ends and ensure compatibility with the switch or NIC vendor for firmware support where applicable.