Actieve optische kabel (AOC) CBO SFP28 LinkSys SFP28-AOC-30M 30 m

Active Optical Cable (AOC) CBO SFP28 LinkSys SFP28-AOC-30M 30 m is a factory-terminated high-speed interconnect designed for direct attachment of SFP28 ports. The cable supports reliable data transmission over a 30-meter distance between compatible network devices with SFP28 interfaces. Intended for low-latency short-reach connections, this AOC is suitable for server-to-switch, switch-to-switch, and storage networking links in data centers and enterprise environments.

Advantages

This SFP28 active optical cable provides stable, low-latency signal delivery and eliminates the need for separate transceivers and fiber patch cords, simplifying installation and inventory. The factory-terminated design ensures consistent optical performance and reduced insertion loss. Its SFP28 connectors maintain hot-pluggable compatibility with SFP28 ports, enabling quick replacements and upgrades without powering down equipment.

Suitable for

• Short-reach 25 Gb/s connections between servers and switches
• High-density switch-to-switch links in racks and top-of-rack deployments
• Storage area network (SAN) interconnects requiring low latency
• Data center patching where simplified cable management is desired

Key specifications

• Cable type: Active Optical Cable (AOC)
• Connector type: SFP28 on both ends
• Length: 30 meters
• Data rate: supports 25 Gb/s (SFP28) links
• Form factor: factory-terminated, hot-pluggable
• Latency: low-latency design suitable for short-reach links

How to use

Install the AOC by inserting each SFP28 connector into the corresponding SFP28 port on your network devices until the latch engages. No additional transceivers, patch cords, or fiber termination are required. After physical installation, verify link status through device LEDs or management interfaces and configure network parameters as needed. For best interoperability, confirm that the connected devices support SFP28 modules and AOC links at the required speed.

Recommendations

Route the cable to avoid tight bends and mechanical stress; maintain bend radii recommended for optical cables. Use intended rack paths and management panels to reduce strain on connectors. Keep connectors clean and protected until installation to prevent contamination. For mixed-vendor environments, verify compatibility in advance and update device firmware if required.