Actieve optische kabel CBO QSFP-100G-AOC-20M 100G 20m

The BlueOptics Optical Active Cable CBO QSFP-100G-AOC-20M 100G 20m is a factory-assembled active optical cable in QSFP form factor that delivers 100 gigabit per second connectivity over a 20 metre reach. It integrates optical transceivers and a pre-terminated duplex fiber link inside a single cable assembly, eliminating the need for separate transceivers and patch cords. The design targets short- to mid-range high-speed interconnects between switches, routers, network interface cards and servers where low latency, predictable performance and reduced rack space are important.

Advantages

This active optical cable provides high aggregate bandwidth and electrical-to-optical conversion within the connector housings for stable 100G links. Because it is pre-terminated and factory-tested, it reduces installation time and the risk of connector mismatches. The integrated solution lowers power consumption and frees transceiver slots on networking equipment, while the 20 m length supports flexible cabling across racks and within data halls without intermediate patching.

Suitable for

• Inter-rack and intra-rack connections in data centres
• High-speed links between switches and aggregation devices
• Server to top-of-rack or leaf switch connections
• Low-latency networking environments and HPC clusters

Key specifications

• Form factor: QSFP
• Data rate: 100 Gbps aggregate
• Length: 20 metres
• Type: Active Optical Cable (AOC) with integrated optical transceivers
• Connector interfaces: QSFP electrical/optical mating
• Typical use case: short to mid-range high-speed interconnects

How to use

Install the cable by plugging each QSFP connector into the corresponding QSFP port on the networking devices, ensuring ports are compatible and powered off or follow hot-plug procedures recommended by the device vendor. The cable is pre-terminated and requires no fiber termination on site. Verify link status through the equipment management interface and monitor for expected link speed and lane status. Handle the cable by the connector housings and avoid tight bends; follow device vendor guidelines for hot-plugging and ESD protection.

Recommendations

For reliable operation, route the cable with gentle bends respecting the manufacturer’s minimum bend radius, avoid sharp kinks and mechanical strain, and maintain clear airflow around equipment. Confirm QSFP port compatibility (electrical and firmware support for 100G AOC modules) with the switch or server vendor before deployment and perform link tests after installation to ensure full performance.