Glasvezel-transceiver CBO GP-10GSFP-1E 10 Gbps SFP+-module

The BlueOptics Fiber Optic Transceiver CBO GP-10GSFP-1E is an SFP+ form-factor module that supports 10 Gbps optical data transmission. Designed for installation in switches, routers and network interface cards, this 10 G transceiver enables high-speed links for data center racks, aggregation layers and enterprise backbone connections. The module is compatible with standard SFP+ ports and can be used with appropriate single-mode or multi-mode fiber and matching optics to achieve the intended short- or long-reach performance.

Advantages

The SFP+ transceiver offers a compact plug-and-play design suitable for hot-swappable installation in compatible network devices. It supports 10 Gbps line rates, providing increased bandwidth compared with 1 G transceivers while maintaining low power consumption typical of SFP+ modules. Built to industry form-factor and optical interface specifications, the module simplifies upgrades by remaining interoperable with standard SFP+ cages and LC fiber connectors when used with matching fiber type and optics.

Suitable for

Key specifications

How to use

Install the transceiver into an empty SFP+ port on a compatible switch, router or network interface card until it clicks into place. Connect LC duplex fiber cable with matching fiber type and polarity between transceivers at both ends. Check device documentation for any required configuration, such as interface enabling or speed settings, and verify link status via device management tools. For safe removal, use the device’s hot-swap procedure, unlatching the module before gently pulling it out to avoid connector or port damage.

Recommendations

Use the transceiver with fiber and patch cords that match the module’s optical type and reach. Ensure proper cleaning of LC connectors before insertion to reduce signal loss. When integrating into production networks, verify compatibility with the host device’s SFP+ specifications and firmware to ensure stable 10 G operation.