BlueOptics JL286A netwerk-transceivermodule glasvezel 40000 Mbit/s QSFP

The BlueOptics JL286A network transceiver module is a fiber optic QSFP module designed to support high-speed data transmission up to 40,000 Mbit/s. Engineered for use in modern network infrastructures, this module provides a compact QSFP form factor that fits into compatible switches, routers and network interface cards. The transceiver supports reliable optical links for aggregated traffic and is suitable for deployment in data centers and enterprise network environments where increased bandwidth and low-latency connectivity are required.

Advantages

The BlueOptics JL286A offers high throughput in a small QSFP package, enabling aggregation of multiple 10 Gbit/s lanes into a single 40 Gbit/s link. Its fiber optic design ensures signal integrity over longer distances compared with copper, and the standardized QSFP interface simplifies installation and replacement in compatible network equipment. The module is intended to meet typical operational needs for scalable, high-bandwidth networks while maintaining a compact physical footprint.

Suitable for

• Data center backbone links and uplinks between switches
• High-performance computing clusters requiring aggregated bandwidth
• Enterprise core and distribution layer connections
• Network equipment upgrades to 40 Gbit/s optical links

Key specifications

• Interface type: QSFP
• Maximum data transfer rate: 40,000 Mbit/s
• Transmission medium: fiber optic
• Form factor: QSFP module (compact hot-pluggable transceiver)

How to use

Install the BlueOptics JL286A into a compatible QSFP slot on your switch, router or network card while following the equipment manufacturer’s hot-plugging and electrostatic discharge (ESD) guidelines. Connect appropriate fiber optic cabling and ensure proper transceiver orientation and connector type matching. After insertion and cable connection, verify link status and configure network ports on the host device to enable the desired 40 Gbit/s operation and any required link aggregation or VLAN settings.

Recommendations

Use certified single-mode or multimode fiber and matching connectors as required by your network design. Confirm compatibility with your network equipment firmware and optics lists before deployment. Keep transceiver ports covered with dust caps when not in use and follow ESD precautions during handling and installation.