Netwerktransceivermodule CBO DEM-432XT SFP+ 10.000 Mbit/s 1310 nm

CBO DEM-432XT is a BlueOptics SFP+ network transceiver module designed for 10,000 Mbit/s optical links over single-mode fiber. The module operates at a 1310 nm wavelength and provides a hot-pluggable SFP+ interface that fits standard SFP+ slots in switches, routers and servers. It enables optical uplinks and point-to-point connections where higher bandwidth and longer reach than copper are required, while maintaining compatibility with equipment that accepts SFP+ modules.

Advantages

The BlueOptics SFP+ transceiver offers a compact, hot-swappable design that simplifies installation and maintenance without powering down equipment. Operating at 10 Gbit/s and 1310 nm wavelength, it supports extended reach over single-mode fiber for backbone links and data center interconnects. The module follows standard SFP+ electrical and optical specifications to ensure interoperability with a wide range of network devices that provide SFP+ ports.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into an empty SFP+ slot on a compatible switch, router or server until it latches. Connect a single-mode fiber with an LC connector to the module’s optical port and secure the fiber to avoid strain. After connection, verify link status and speed on the host device and configure port settings as required by your network. The hot-pluggable design allows replacement or installation without shutting down the system.

Recommendations

Ensure the host device supports SFP+ modules with 10 Gbit/s optics and the 1310 nm wavelength. Use single-mode fiber with appropriate attenuation and clean connectors to maintain signal quality. Follow equipment vendor guidance for supported transceiver models and firmware compatibility when planning upgrades or replacements.