SFP-glasvezeltransceiver CBO SFP-1G-EX 1 Gbit/s single-mode 1G

CBO SFP-1G-EX is a compact SFP fiber transceiver that provides 1 Gbps data transmission over single‑mode fiber. Designed to fit standard SFP ports, this BlueOptics module enables extended reach optical links for network switches, routers and fiber patch panels. The module supports hot‑plug insertion and interoperates with compatible networking equipment to deliver stable single‑gigabit connections in enterprise, data center and telecom environments.

Advantages

The CBO SFP-1G-EX combines small form factor design with single‑mode optics to offer long‑reach connectivity while occupying minimal port space. Built for compatibility with common SFP interfaces, it supports hot‑swapping without interrupting adjacent ports. Low power consumption and standardized electrical/optical characteristics provide predictable performance and ease of integration into existing fiber infrastructures.

Suitable for

• Enterprise access and aggregation links
• Data center uplinks between switches and routers
• Telecommunication point‑to‑point fiber links
• Campus and metropolitan area network fiber connections

Key specifications

• Form factor: SFP (small form‑factor pluggable)
• Data rate: 1 Gbps (single‑gigabit Ethernet)
• Fiber type: single‑mode fiber
• Optical interface: typical SC or LC connector compatibility dependent on host cable assemblies
• Transmission distance: designed for extended‑reach single‑mode links (distance depends on fiber type and link budget)
• Wavelength: single‑mode optical wavelength suitable for long‑reach operation
• Power consumption: low power SFP class, suitable for switch/router SFP ports

How to use

Insert the CBO SFP-1G-EX module into an empty SFP port on a network switch, router or fiber media converter while the host device is powered on or off according to the host manual. Connect the single‑mode fiber patch cable to the module’s optical port, taking care to match connector types and preserve fiber cleanliness. Configure the host interface for 1 Gbps operation if necessary; many devices negotiate link speed automatically. Verify link status on the host device and test throughput to confirm correct installation.

Recommendations

Handle the optical ports with dust caps when not connected, follow ESD precautions during installation, and use appropriate single‑mode fiber patch cords and attenuators if required by link power levels. Consult host device documentation for any vendor compatibility notes and enable appropriate interface settings to ensure stable 1 Gbps operation.