SFP+ koper-transceiver CBO SFP-10G-RJ45-80M 10 Gbit/s

The BlueOptics SFP+ Copper Transceiver CBO SFP-10G-RJ45-80M 10 Gbps is a compact hot-pluggable module for 10 Gigabit Ethernet over standard RJ45 copper cabling. It is designed to fit any device with an SFP+ slot and provides a straightforward way to add 10 Gbps copper connectivity for short-range links up to 80 meters on compatible Cat6a/Cat7 installations. The transceiver is intended for use in switches, routers and servers where a cost-effective copper alternative to fiber is required and where easy field replacement is important.

Advantages

This SFP+ copper transceiver supports a full 10 Gbps data rate while offering plug-and-play installation and hot-swap capability. Its RJ45 interface allows use with common structured cabling, avoiding the need for fiber optics for short links. The module's compact SFP+ form factor saves space in network equipment and simplifies upgrading ports to 10 Gbps. Designed for enterprise and data center environments, the transceiver provides predictable short-range performance and compatibility with SFP+ host ports.

Suitable for

• Short-range 10 Gbps copper links in data centers and wiring closets
• Upgrading switches, routers or servers with SFP+ ports to 10 Gbps copper
• Temporary links or lab environments where fiber is unnecessary
• Cost-conscious deployments that use existing Cat6a/Cat7 cabling

Key specifications

• Interface: SFP+ form factor with RJ45 connector
• Data rate: 10 Gbps Ethernet
• Maximum link distance: up to 80 meters on compatible cabling
• Cable compatibility: shielded twisted-pair copper (Cat6a/Cat7 recommended)
• Hot-pluggable: supports hot-swap insertion and removal
• Typical application: short-range copper connections in enterprise networks and data centers

How to use

Insert the transceiver into an available SFP+ slot on the network device until it clicks into place, then connect a suitable RJ45 cable to the module and the remote device. Ensure the cabling is rated and installed properly for 10 Gbps operation and that link settings on both ends are configured to use 10GBASE-T or autonegotiation as supported by the host equipment. The module supports hot-swap, so it can be inserted or removed while the host is powered, though following standard electrostatic discharge precautions and change-control procedures is recommended.

Recommendations

To achieve the specified performance, use high-quality Cat6a or Cat7 shielded cabling and keep link lengths within the supported 80 m range. Verify compatibility with the host device firmware and consult device documentation for any vendor-specific compatibility notes. For critical links, monitor link status and error counters after installation to confirm stable 10 Gbps operation.