SFP+ transceiver CBO SFP-10G-BX-U 10G 1310nm

The BlueOptics SFP+ Transceiver CBO SFP-10G-BX-U 10G 1310nm is a compact hot-pluggable module that provides 10 Gigabit optical connectivity over a 1310 nm wavelength. Designed for use in SFP+ ports of switches, routers and servers, this single-fiber bidirectional transceiver supports high-speed uplinks and links in data centers and enterprise networks. Its small form factor and single-fiber operation simplify cabling and reduce port footprint while maintaining reliable 10G performance for point-to-point connections.

Advantages

The module offers single-fiber bidirectional transmission which reduces fiber cabling requirements and enables duplex-equivalent links using only one fiber. Hot-pluggable design allows replacement and upgrades without powering down the host device, minimizing downtime. Compatibility with SFP+ ports and standard 10G signaling ensures interoperability with a wide range of network equipment that accepts SFP+ optical modules. The 1310 nm wavelength is suitable for short- to medium-reach links in typical enterprise and data center environments.

Suitable for

• 10 Gigabit uplinks between switches and aggregation devices
• Server connections to top-of-rack switches in data centers
• Single-fiber bidirectional links where fiber count must be minimized
• Network equipment upgrades that require SFP+ optical transceivers

Key specifications

• Data rate: 10 Gbps (SFP+ compatible)
• Operating wavelength: 1310 nm
• Form factor: SFP+ hot-pluggable transceiver
• Transmission type: single-fiber bidirectional (BiDi)
• Typical application: short- to medium-reach optical links in enterprise and data center networks

How to use

Install the transceiver into an available SFP+ slot on the switch, router or server until it clicks into place. Connect a compatible single-fiber patch cable or adapter to the module’s optical interface, observing the correct orientation for transmit and receive channels. After insertion, verify link and speed status through the host device’s management interface or LED indicators. To remove the module, release any retention mechanism and gently pull the transceiver straight out; protect the optical ports with dust caps when not in use.

Recommendations

Use the module in equipment that supports SFP+ optical transceivers and verify compatibility with the host vendor if required. Keep optical connectors and transceiver ports clean to maintain signal quality. Avoid excessive bending of fiber and maintain appropriate operating temperature and handling procedures to ensure reliable 10G operation.