SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm

The SFP+ Transceiver CBO SFP-10G-ER-1310 10G 1310nm is a compact optical module designed for 10 Gigabit Ethernet links over single-mode fiber at a 1310 nm wavelength. Intended for installation in compatible SFP+ slots, this transceiver supports long-reach connections and hot-pluggable operation, enabling straightforward integration into switches, routers and optical line equipment used in data centers, enterprise backbones and carrier networks.

Advantages

This SFP+ transceiver offers 10 Gbps bandwidth over single-mode fiber with a 1310 nm wavelength optimized for extended reach applications. Its hot-pluggable form factor simplifies maintenance and upgrades without system downtime. The module adheres to common SFP+ electrical and optical interfaces, which promotes interoperability with a wide range of host devices and helps reduce inventory complexity for mixed-vendor environments.

Suitable for

• Data center uplinks and aggregation links
• Enterprise backbone and campus network interconnects
• Carrier and telecom long-haul or metro links over single-mode fiber
• Integration into switches, routers and optical transport equipment with SFP+ ports

Key specifications

• Nominal data rate: 10 Gigabit Ethernet
• Operating wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+ (hot-pluggable)
• Connector type: LC duplex
• Typical reach: designed for extended-reach single-mode links (long-reach applications)

How to use

Insert the transceiver into a compatible SFP+ port on the host device until it clicks into place. Connect LC duplex single-mode fiber patch cords, ensuring correct transmit-to-receive alignment. After physical installation, verify link status via the host device management interface and configure interface parameters as required by the network (speed, duplex, MTU, and any VLAN or trunk settings). For safe removal, disable the port or shut down the interface in the host before gently extracting the module.

Recommendations

Use clean, certified single-mode fiber and LC connectors to maintain signal integrity. Avoid exposing the optical interface to dust or direct sunlight; always use dust caps when the transceiver is not connected. Observe manufacturer guidelines for operating temperature and ESD handling. Verify compatibility with the host device and check link budget requirements for the intended distance and fiber type.