SFP+-transceiver CBO SFP-10G-ER-1310 10G 1310nm

SFP+ Transceiver CBO SFP-10G-ER-1310 10G 1310nm is a hot-pluggable optical module that supports 10 Gigabit Ethernet and Fiber Channel links over single-mode fiber. Operating at a 1310 nm wavelength, this transceiver is intended for long-reach connections where stable, high-speed optical transport is required. The module fits standard SFP+ ports on switches, routers and servers, enabling straightforward installation and straightforward replacement without powering down equipment.

Advantages

The transceiver provides 10 Gbps data rate with low power consumption and hot-pluggable convenience, reducing downtime during maintenance or upgrades. Its single-mode 1310 nm design allows extended link distances while maintaining signal integrity and compatibility with common network equipment. The compact SFP+ form factor saves space in high-density installations and simplifies inventory by supporting both Ethernet and Fiber Channel environments.

Suitable for

• Long-reach 10 Gigabit Ethernet connections over single-mode fiber
• Data center uplinks and inter-switch links requiring 1310 nm wavelength
• Server-to-switch or router-to-switch 10G optical connections
• Fiber Channel links in storage area networks requiring 10G optical transceivers

Key specifications

• Optical wavelength: 1310 nm
• Data rate: 10 Gbps
• Form factor: SFP+
• Fiber type: single-mode fiber (SMF)
• Hot-pluggable: yes
• Typical link distance: designed for long-reach applications (single-mode)
• Compatible protocols: 10 Gigabit Ethernet, Fiber Channel

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your switch, router or server until it clicks into place. Connect single-mode fiber patch cords with appropriate connectors to the transceiver's optical ports, ensuring correct polarity. Verify link status through the device management interface and monitor optical power and diagnostics if supported. To remove, disengage any retention mechanisms and pull the module straight out while the host device remains powered if hot-swap is supported.

Recommendations

Use clean single-mode fiber and inspect connectors before insertion to prevent signal loss. Ensure transceiver compatibility with your network equipment and verify link budget for long-reach runs. Store unused transceivers with dust caps and maintain static-safe handling to protect the optical interface and electronics.