SFP+ transceiver CBO SFP-10G-LRM glasvezel 10G LRM module

The BlueOptics SFP+ Transceiver CBO SFP-10G-LRM Fiber Optic 10G LRM Module is a compact, hot-pluggable SFP+ transceiver designed for 10 Gbps links over short-range multimode fiber. It provides a standardized interface for switches, routers and servers, enabling straightforward upgrades or replacements for existing 10G LRM ports. The module is intended for reliable high-speed data transmission in data centers, server rooms and enterprise LAN environments where multimode cabling is used.

Advantages

This SFP+ LRM module offers a small form factor with hot-swappable capability, allowing fast installation or replacement without powering down equipment. It supports 10 Gbps data rates over multimode fiber for short distances, reducing the need for more expensive single-mode optics for local connections. The module follows common SFP+ electrical and optical interfaces to ensure compatibility with a range of network devices and simplifies cabling and maintenance tasks.

Suitable for

• Upgrading or replacing 10G LRM ports in network switches and routers
• Short-range multimode fiber links in data centers and server rooms
• High-speed uplinks between racks or between switches within the same facility
• Enterprise LAN segments requiring 10 Gbps connectivity over multimode cable

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbps
• Optical interface: multimode fiber (LRM)
• Typical reach: short-range multimode distances (LRM-class)
• Connector: duplex LC

How to use

Insert the SFP+ transceiver into an available SFP+ port on the network device until it clicks into place, ensuring the device supports 10G LRM optics. Connect duplex multimode LC patch cables between the transceiver and the corresponding port or patch panel. After installation, verify link status and configure device interfaces as required by the switch or router operating system. For removal, power down the interface if recommended by the equipment vendor, then press the release tab and pull the module straight out.

Recommendations

Use high-quality multimode LC patch cables and ensure fiber connectors are clean to maintain signal integrity. Confirm device compatibility with SFP+ LRM optics and check link settings after installation. Avoid exposing the transceiver to electrostatic discharge and handle the optical port dust caps until ready to connect.