SFP+ transceiver-module CBO voor HPE Aruba J9150D 10GBASE-SR optisch 10 Gbit/s multimode

The SFP+ transceiver module CBO for HPE Aruba J9150D 10GBASE-SR optical 10Gbps multimode is a hot-pluggable 10 Gigabit Ethernet optical module compatible with SFP+ ports. It provides short-range 10Gbps connectivity over multimode fiber, intended for use in switches and servers that accept SFP+ form-factor optics. The module is designed as a replacement or upgrade for 10GBASE-SR optics in HPE Aruba environments, offering fiber connectivity for data center uplinks, server links and short-distance aggregation connections.

Advantages

This SFP+ 10GBASE-SR transceiver supports a full 10Gbps data rate over multimode fiber and fits standard SFP+ cages, allowing straightforward installation without configuration changes. The module is interoperable with HPE Aruba devices that accept the J9150D specification, enabling cost-effective replacement of original optics. Its optical design is optimized for short-range links, reducing signal loss and maintaining reliable link performance in typical data center and campus cabling scenarios.

Suitable for

• 10 Gigabit short-range links within data centers using multimode fiber
• Inter-switch uplinks and server-to-switch connections at distances appropriate for 10GBASE-SR
• Replacement of existing 10G SFP+ optics in HPE Aruba-compatible network equipment
• Network equipment testing and spare parts stocking for installations using multimode fiber

Key specifications

• Form factor: SFP+ (10G)
• Optical interface: 10GBASE-SR for multimode fiber
• Data rate: 10 Gbps
• Wavelength: multimode SR optical wavelength (short-range multimode)
• Connector type: duplex LC

How to use

Insert the SFP+ transceiver into an available SFP+ port on a compatible switch or server until it clicks into place. Connect duplex multimode fiber with LC connectors to the module, observing correct transmit/receive orientation. Power on the host equipment and verify link status through the device management interface or LEDs. No additional configuration is normally required on devices that accept SFP+ optics; monitor link parameters and error counters to confirm stable operation.

Recommendations

Use in environments with verified multimode cabling and within the distance limits of 10GBASE-SR. Handle the transceiver by the housing, keep the optical connectors clean with dust caps when not connected, and follow electrostatic discharge (ESD) precautions during installation and removal.