SFP-transceivermodule CBO SFP-10G-BX-U-NV-BO 10G 10000 Mbit/s

CBO SFP-10G-BX-U-NV-BO is a BlueOptics SFP transceiver module that supports 10G (10000 Mbit/s) data rates in the compact SFP form factor. It is engineered for installation in compatible switches and routers with SFP ports to provide high-speed optical connectivity for data centers, enterprise networks and service providers. The module enables reliable short- to medium-range fiber links and is suitable where a 10G SFP solution is required to increase throughput and lower latency.

Advantages

This SFP transceiver offers a standardized 10G interface in a small SFP package, ensuring broad compatibility with devices that support SFP optics. It supports hot-plug installation for minimal network disruption and provides stable optical performance for high-bandwidth applications. The module is designed to meet typical environmental and electrical requirements of networking equipment, delivering an efficient option to extend network capacity without replacing existing chassis or line cards.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Aggregation links in data center and campus networks
• Service provider access links and metro connections
• Upgrading server connections to 10G SFP ports

Key specifications

• Data rate: 10 Gbit/s
• Form factor: SFP (small form-factor pluggable)
• Optical link: short- to medium-range fiber transmission
• Interface type: optical SFP port compatible
• Application: 10 Gigabit Ethernet and similar high-speed optical links

How to use

Insert the transceiver into an appropriate SFP slot on a compatible switch or router until it clicks into place, then connect the fiber cable with the correct connector type for the module. Verify that the host device recognizes the module and that link/activity LEDs indicate a stable connection. Configure the network interfaces in the device operating system as required for speed, duplex and relevant protocols.

Recommendations

Confirm compatibility with the host equipment’s supported SFP modules and firmware. Use quality single-mode or multimode fiber and matched connectors according to the module’s optical requirements. Handle the optical interfaces carefully: keep dust caps on when not in use and follow ESD-safe procedures during installation and removal.