SFP+-transceivermodule CBO SFP-10G-ZR-NV-BO, 10 Gbit/s, singlemode, tot 10 km

CBO SFP-10G-ZR-NV-BO is an SFP+ transceiver module that supports 10 Gbit/s data transmission over single-mode fiber with a reach of up to 10 km. The module is intended for use in switches, routers and other optical networking equipment where a compact hot-pluggable interface is required. It provides a standard SFP+ form factor that enables easy installation and replacement without powering down the host device.

Advantages

This SFP+ transceiver offers 10 Gigabit performance for uplinks and point-to-point links on single-mode fiber, combining high data throughput with a small, hot-pluggable package. It is compatible with common SFP+ ports and is designed to deliver stable optical signal quality over distances up to 10 km. The module's single-mode design minimises modal dispersion for longer reach compared with multimode solutions, and the standard form factor supports straightforward maintenance and scalability in rack-mounted and modular systems.

Suitable for

• Data center uplinks and server-to-switch connections
• Metro aggregation links and carrier access segments
• Enterprise backbone and campus network trunking
• Optical equipment requiring hot-pluggable 10 Gbit/s transceivers

Key specifications

• Interface: SFP+ hot-pluggable form factor
• Data rate: 10 Gbit/s
• Fiber type: single-mode fiber
• Maximum link distance: up to 10 km on standard single-mode fiber
• Wavelength: suitable for long-reach single-mode transmission
• Power consumption: low power design suitable for switch and router modules

How to use

Insert the transceiver into a compatible SFP+ port on a powered network device, observing proper orientation until it clicks into place. Connect single-mode fiber patch cables with appropriate connectors to the transceiver ports, ensuring correct transmit/receive alignment. The host device should detect the module and negotiate a 10 Gbit/s link; verify link status and optical levels through the device management interface. For removal, power down the port if recommended by the equipment vendor or use the transceiver’s latch to extract it while following hot-swap procedures specified by the host device.

Recommendations

Use single-mode fiber with recommended connector types and maintain clean fiber endfaces to ensure reliable optical performance. Verify compatibility with the host device and monitor optical link parameters after installation. Avoid bending the fiber beyond specified limits and operate the module within the manufacturer’s temperature and power ratings to maintain link stability.