Transceiver CBO PSFP-1000-M2LC05 glasvezel 1000Mbps 550m

The Transceiver CBO PSFP-1000-M2LC05 Fiber Optic 1000Mbps 550m is a hot-pluggable SFP module designed to extend Ethernet links over fiber with a 1 Gbps data rate and a maximum reach of 550 meters. It is compatible with standard SFP ports on network switches, routers and media converters, and can be used with single-mode or multimode fiber depending on the physical cabling and connector type. The module supports fibre optic connectivity for campus, office and data center applications where stable, low-latency point-to-point links are required.

Advantages

The transceiver offers plug-and-play installation with hot-swap capability, allowing upgrades or replacements without shutting down connected equipment. With a 1 Gbps throughput and up to 550 m reach, it enables reliable Ethernet extension across short to medium fiber runs. The compact SFP form factor provides broad compatibility with various network devices and conserves port space, while fiber connectivity reduces electromagnetic interference and provides improved signal integrity compared with copper cabling.

Suitable for

• Connecting switches and routers over fiber within campus and office buildings
• Extending Ethernet links between server racks or within small data centers
• Linking media converters to fiber infrastructure for network extension
• Replacing or adding hot-pluggable SFP ports to support fiber uplinks

Key specifications

• Data rate: 1000 Mbps (1 Gbps)
• Maximum reach: up to 550 meters over appropriate fiber
• Form factor: SFP (hot-pluggable)
• Connector type: LC duplex
• Optical medium: compatible with single-mode or multimode fiber depending on deployment
• Operating conditions: designed for standard network equipment environments (room temperature and typical indoor conditions)

How to use

Insert the SFP transceiver into an available SFP slot on a compatible switch, router or media converter while the device is powered on or off; the module supports hot-plug operation. Connect LC duplex fiber cables with the correct fiber type (single-mode or multimode) and ensure transmit/receive pairs are correctly oriented. Verify link status through the network device indicators or management interface and configure the port settings (speed, duplex, auto-negotiation) if required by your equipment. Handle the transceiver and fiber connectors carefully to avoid contamination or damage to optical endfaces.

Recommendations

Keep protective dust caps on the transceiver and fiber connectors when not in use, inspect and clean connector endfaces before insertion, and match the fiber type and connector polarity to the requirements of your network to ensure optimal performance and reliable links.