Transceivermodule CBO 10G-SFPP-LR-BO 10G 1310nm SFP+

CBO 10G-SFPP-LR-BO is a BlueOptics SFP+ transceiver module engineered for 10 Gbps optical links over single-mode fiber using a 1310 nm wavelength. The module fits into compatible SFP+ ports of network switches, routers and optical equipment to enable long-reach point-to-point connections. It is intended for deployment in environments that require stable 10G transmission such as data center uplinks, metro aggregation and enterprise backbone links.

Advantages

The SFP+ module supports a 10 Gbps data rate and is optimized for single-mode fiber long-reach connections at 1310 nm, delivering stable optical performance and predictable link behavior. Its form factor conforms to standard SFP+ interfaces for hot-pluggable installation, which simplifies maintenance and equipment upgrades without downtime. The BlueOptics design focuses on compatibility with a wide range of network hardware and predictable thermal and signal characteristics for continuous operation.

Suitable for

• Data center uplinks and server aggregation
• Metro Ethernet and carrier access links
• Enterprise backbone and WAN links between buildings
• Optical network equipment requiring 10G single-mode connections

Key specifications

• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Form factor: SFP+ (hot-pluggable)
• Fiber type: single-mode fiber (SMF)
• Typical reach: long-reach links (designed for extended single-mode distances)
• Connector type: LC duplex

How to use

Install the transceiver by inserting it into an empty SFP+ port on a compatible switch, router or optical device until it clicks into place. Attach LC duplex single-mode fiber cables to the transceiver's connector, verifying correct TX/RX orientation. Configure the device interface for 10 Gbps operation if required by the host equipment and check link status indicators to confirm successful negotiation. For replacement or upgrade, remove the module by releasing the latch mechanism and pulling it straight out, then insert the new module following the same steps.

Recommendations

Operate the module within the host device’s specified temperature range and avoid excessive bending or stress on fiber cables. Use compatible SFP+ ports and verify vendor compatibility if the host equipment enforces vendor checks. Clean fiber connectors before mating and observe electrostatic discharge precautions during handling.