Boor Bosch SDS plus-7X 10 x 150 mm, 10-delige set

Bosch SDS plus-7X 10 x 150 mm drill bit set contains ten identical SDS-plus shank bits engineered for rotary hammers. Each 10 mm diameter, 150 mm length bit is designed to drill clean, accurate holes in concrete, masonry and natural stone. The set is compatible with SDS-plus chucks and intended for tasks that require reliable anchoring and through-fixing, offering consistent drilling performance for both professional tradespeople and advanced DIY users.

Advantages

The SDS plus-7X design provides reduced vibration transfer and improved bit guidance in rotary hammer applications, helping to maintain hole precision and extend bit life. The carbide tip geometry enhances drilling speed and wear resistance in hard materials, while the 150 mm working length enables deeper holes without changing bits. Sold as a set of ten, the pack helps maintain workflow continuity on job sites and reduces downtime for frequent drilling tasks.

Suitable for

• Drilling anchor holes for bolts and fixings in concrete and masonry
• Through-holes for passages and service installations in walls
• General construction and renovation drilling tasks
• Professional and advanced DIY projects requiring SDS-plus rotary hammers

Key specifications

• Shank type: SDS-plus
• Diameter: 10 mm
• Overall/working length: 150 mm
• Pack quantity: 10 pieces
• Tip material: carbide (toughened tip for masonry)
• Intended materials: concrete, masonry, natural stone

How to use

Install the SDS-plus bit into the rotary hammer chuck until it locks. Select the hammer-drill mode appropriate for the base material and start drilling with steady axial pressure; avoid excessive sideways force. For deeper holes, periodically withdraw the bit to clear accumulated dust and debris, which maintains drilling efficiency and prevents overheating. Replace bits from the set when wear or chipping reduces drilling performance.

Recommendations

Use appropriate personal protective equipment such as eye protection, hearing protection and dust masks when drilling. Match the 10 mm diameter to the correct anchor or fixing size and verify that the 150 mm length suits the required embedment depth. Store bits dry and clean to prevent corrosion and check compatibility with your SDS-plus rotary hammer before use.