Buildplate Creality 3D 4004090103 voor Ender-3 S1 Ender-5 S1

The Creality 3D 4004090103 buildplate for Ender-3 S1 and Ender-5 S1 series is a replacement printing surface designed to improve first-layer adhesion and provide a stable base for a wide range of filament types. Compatible with Ender-3 S1, Ender-3 S1 Pro, Ender-5 S1 K1 and Ender-3 V3 SE models, this single-piece black buildplate installs in place of the original surface to restore or enhance bed performance and print quality.

Advantages

This buildplate offers improved adhesion for both PLA and other common filaments, helping to reduce warping and failed first layers. Its matte black finish provides a consistent surface texture that supports even filament flow and easier part removal after cooling. Lightweight and durable, the plate maintains flatness during normal operation and is supplied as a single unit for convenient replacement.

Suitable for

• Upgrading or replacing the printing surface on compatible Creality Ender models
• Printing PLA, PETG and similar filaments where improved bed adhesion is required
• Users restoring print quality after wear or damage to an existing buildplate
• General-purpose desktop 3D printing tasks requiring consistent first-layer performance

Key specifications

• Type: buildplate / printing surface
• Compatible models: Ender-3 S1, Ender-3 S1 Pro, Ender-5 S1 K1, Ender-3 V3 SE
• Colour: black
• Weight: approximately 0.43 kg
• Pack quantity: 1 piece

How to use

Allow the printer and buildplate to cool before removing the old surface. Remove any clips or fasteners holding the previous plate in place, then align the new buildplate on the printer’s heated bed according to the manufacturer’s mounting points. Reinstall any clamps or magnetic bed fixtures and perform a manual or automatic bed-leveling procedure to set the correct nozzle offset. Begin prints with a standard first-layer calibration pattern to confirm adhesion and adjust Z-offset or bed temperature if necessary.

Recommendations

For optimal results, clean the buildplate surface with isopropyl alcohol before each print to remove oils and dust. Use a brim or raft for models with small contact areas to increase stability during printing, and allow parts to cool before removal to reduce the risk of deformation.