CBO AOC SFP+ BlueOptics BO353503J15M 10G 15M

The CBO AOC SFP+ BlueOptics BO353503J15M 10G 15M is an active optical cable that provides a direct SFP+ to SFP+ link over a fixed 15-metre length for 10 Gigabit Ethernet environments. Designed for use with compatible SFP+ ports on switches, servers and storage systems, the cable integrates optical transceivers and a pre-terminated fibre core to deliver low-latency, energy-efficient connectivity while reducing the need for separate optical transceivers and patch panels. The factory-terminated assembly simplifies deployment in data centre and enterprise networks where predictable link performance and compact cabling are required.

Advantages

This BlueOptics AOC offers a fixed-length, lightweight optical connection that reduces electrical interference and heat compared with copper alternatives. The integrated optical transceiver design eliminates separate modules and lowers overall power consumption at the port level. The 15-metre length covers medium-distance runs within racks and between adjacent racks or network rooms, simplifying cable management and minimising signal loss typically associated with longer patching chains.

Suitable for

• 10G Ethernet uplinks between switches
• Server-to-switch and storage-to-switch connections
• Data centre spine-to-leaf and rack-to-rack links
• High-density network installations requiring compact cabling

Key specifications

• Interface: SFP+ to SFP+ active optical cable
• Data rate: 10 Gigabit Ethernet
• Length: 15 metres (fixed)
• Connector type: SFP+ form factor
• Latency: low-latency optical transmission suitable for high-throughput applications
• Power: reduced port power consumption compared with separate transceiver plus copper cabling
• Cable type: factory-terminated active optical assembly

How to use

Install the AOC by inserting each SFP+ connector into the corresponding SFP+ slot on your network devices until the module latches. Ensure both ends are fully seated and that the host devices support SFP+ AOC modules. After physical installation, verify link status and speed in your equipment management interface and configure the ports as required. For replacement, power down the port if recommended by the device vendor, carefully remove the module by disengaging the latch, and insert the new cable following the same steps.

Recommendations

Use this 15-metre active optical cable in straight runs without tight bends; maintain the manufacturer’s minimum bend radius to avoid signal degradation. Verify compatibility with your switch and server vendors for SFP+ AOC operation and check firmware requirements if a link fails to come up. Store and route the cable to avoid sharp kinks and protect connectors with dust caps when not installed.