CBO AOC SFP+ BlueOptics BO353503J2M 10G 2M actieve optische kabel

The CBO AOC SFP+ BlueOptics BO353503J2M 10G 2M active optical cable is a factory-terminated SFP+ to SFP+ link designed for short-range 10 Gbps connections. With a 2 metre fibre assembly and SFP+ form-factor connectors, this active optical cable provides low-latency, high-bandwidth connectivity between switches, servers and network appliances without the need for separate optical transceivers or patch panels. The design supports electrical isolation and reduced electromagnetic interference compared to copper alternatives, while maintaining plug-and-play compatibility with standard SFP+ ports.

Advantages

This BlueOptics active optical cable delivers 10 Gbps data rates over a compact 2 m length while consuming less power than comparable optical transceiver plus patch-cord combinations. The integrated active components ensure reliable signal conditioning and extended reach for short-range links. The SFP+ interfaces simplify installation and hot-plug operation, and the fibre medium provides inherent galvanic isolation and improved immunity to electromagnetic disturbances in dense rack environments.

Suitable for

• Rack-to-rack and intra-rack connections in data centres
• Direct links between switches and top-of-rack devices
• Server-to-switch 10 Gbps uplinks
• High-density network deployments requiring low power and low heat

Key specifications

• Interface: SFP+ to SFP+
• Data rate: 10 Gbps
• Cable type: active optical cable (AOC)
• Length: 2 metres
• Form factor: SFP+ compatible plug-and-play connectors
• Electrical isolation: optical medium provides galvanic isolation
• Power consumption: lower than equivalent optics-plus-copper solutions (typical for AOC designs)

How to use

Insert each SFP+ connector into the SFP+ port on the network devices until the module latches. Verify that link LEDs or management interfaces report an active 10 Gbps connection. No additional transceivers, patch panels or fibre termination are required. For hot-plug operations, follow the hardware vendor’s guidelines for safe insertion and removal to avoid port or module damage. Monitor link status and device logs after installation to confirm stable operation.

Recommendations

Use the cable for short-range, high-bandwidth links up to 2 m in length and avoid excessive bending or tension on the fibre assembly. Keep connectors capped when not in use, and follow your equipment manufacturer’s port compatibility list to ensure full interoperability.