CoreParts MMD2614/4GB geheugenmodule DDR3 240-pins DIMM ECC

The CoreParts MMD2614/4GB memory module is a 4GB DDR3 DIMM with a clock speed of 1333 MHz and ECC support. Designed to match the performance of original RAM modules, it uses original chip sets from certified suppliers and is intended to improve system reliability and data integrity. The module comes in a green PCB color and is suitable for systems that accept DDR3 ECC memory.

Advantages

Supports ECC (error-correcting code) to detect and correct single-bit memory errors, helping protect data integrity. The 1333 MHz clock speed provides compatible performance with many DDR3 platforms. Manufactured using original chip sets from certified suppliers to ensure consistent operation and compatibility.

Suitable for

• Servers and workstations requiring ECC memory
• Systems with DDR3 memory slots supporting 1333 MHz modules
• Upgrading existing DDR3 setups to add 4 GB capacity

Key specifications

• Internal memory: 4 GB
• Memory type: DDR3
• Clock speed: 1333 MHz
• ECC: Yes (error-correcting code)
• Product colour: Green
• Weight: 0.01 kg
• Brand: MicroMemory
• MPN: MMD2614/4GB
• EAN: 5711045676109

How to use

Power off the computer and disconnect it from the power source. Open the case and locate an available DDR3 DIMM slot that supports ECC modules. Align the module with the slot notch and press down evenly until the module clicks into place and retention clips engage. Close the case, reconnect power, and boot the system. Verify in the BIOS/UEFI or operating system that the new 4 GB module is recognized and that ECC is enabled if supported by the motherboard.

Recommendations

Install memory modules of the same type and speed for optimal compatibility. Confirm motherboard and CPU support for DDR3 ECC before purchase. Handle the module by its edges and observe electrostatic discharge (ESD) precautions during installation.