CPU-koeler Jonsbo CR-1000MAX 120mm RGB wit — single-tower luchtkoeler, 120mm-ventilator, RGB-verlichting

Jonsbo CR-1000MAX 120mm RGB White is a single-tower air cooler finished in white, equipped with a 120mm fan and integrated RGB lighting. It is designed to provide active air cooling for desktop processors in standard and compact PC builds. The cooler combines a vertical fin stack with a single high-performance fan to improve heat dissipation from the CPU while adding a customizable RGB accent to the system interior.

Advantages

The single-tower design offers a compact footprint that is easier to fit in narrower cases and smaller motherboards. A 120mm PWM fan balances airflow and acoustic performance for everyday use, gaming and workstation loads. The RGB lighting is compatible with common motherboard control standards to allow color and effect adjustment. The white finish gives a neutral aesthetic that pairs well with light-themed builds.

Suitable for

• Home and office desktop PCs with mainstream CPUs
• Gaming rigs where space is limited or a mid-range cooler is required
• Compact builds and small ATX/mATX cases with limited cooler clearance
• Systems where a simple RGB visual accent is desired

Key specifications

• Cooling type: single-tower air cooler with 120mm fan
• Fan size: 120 mm
• Lighting: integrated RGB lighting with motherboard-compatible control
• Finish: white exterior on heatsink and fan housing
• Compatibility: designed for modern desktop CPU sockets (check motherboard and case clearance)
• Intended use: consumer, gaming and workstation environments with typical thermal loads

How to use

Install the cooler following the included mounting instructions for your specific CPU socket. Ensure the backplate and mounting brackets are correctly aligned and that thermal paste is applied between the CPU heatspreader and the cooler base. Mount the 120mm fan onto the tower in the specified orientation to direct airflow toward the rear or top case exhaust. Connect the fan PWM cable to the CPU fan header on the motherboard and the RGB cable to the appropriate RGB header or controller. After installation, verify in BIOS or using motherboard software that the fan control and RGB lighting respond as expected.

Recommendations

For best results, confirm case cooler clearance and RAM height to avoid interference with the single-tower layout. Set a PWM fan curve in BIOS or system software to balance cooling and noise according to workload. Periodically clean dust from the fan and fin stack to maintain thermal performance and consistent RGB lighting operation.