DMX-kabelset EUROLITE 20000429 — 2×0,22 mm² ader, 100 m rol

EUROLITE DMX cable set 20000429 consists of a 100 m reel of cable with two 0.22 mm² conductors designed for DMX512 signal transmission in lighting and stage control systems. The single-reel format provides a continuous length for long cable runs between controllers and fixtures, reducing the number of joins and the risk of signal loss. The cable construction is intended for temporary installations, events, and touring where reliable data transmission and easy handling are required.

Advantages

The cable set offers a long, uninterrupted 100 m length that simplifies setup for extended runs and minimizes connectors. Two 0.22 mm² conductors provide the conductor cross-section commonly used in DMX applications, balancing flexibility with adequate signal carrying capacity. The reel format keeps the cable organized for transport and deployment and reduces handling time during installation and strike. The construction aims to maintain signal integrity across typical event distances when used within recommended DMX topology and termination practices.

Suitable for

Key specifications

How to use

Unwind the required length from the reel and route the cable between the DMX controller and fixtures following recommended DMX topology (daisy-chain/TRS or XLR as appropriate to your connectors). Ensure proper shielding and separation from power cables where possible to reduce interference. Install a DMX terminator at the end of the line and verify connections before powering devices. Rewind the cable onto the reel after use to maintain order and protect the insulation.

Recommendations

For reliable DMX performance, use the cable within standard DMX512 run lengths or with repeaters/splitters where longer networks are needed; avoid sharp bends and mechanical strain on the conductors, and keep the cable away from high-voltage power lines to minimize interference.