Draadloze DMX-zender EUROLITE QuickDMX 70064700 voor de afstandsbediening van DMX512

The EUROLITE QuickDMX 70064700 is a wireless DMX transmitter designed to send DMX512 control signals to compatible lighting fixtures and receivers. This device creates a cable-free connection for remote control of stage, event, and architectural lighting, simplifying setup and reducing cable runs. The transmitter pairs with compatible QuickDMX receivers to extend DMX control into areas where cabling is impractical or unsafe, maintaining the DMX512 protocol for reliable lighting control.

Advantages

The QuickDMX transmitter eliminates the need for long DMX cable runs, reducing installation time and tripping hazards. It supports standard DMX512 signal transmission with stable wireless performance and straightforward pairing to compatible receivers. Compact and lightweight, the unit integrates easily into existing lighting setups and can be mounted or positioned to optimize line-of-sight communication. Powering and LED indicators enable quick status checks during setup and operation.

Suitable for

Key specifications

How to use

Connect the EUROLITE QuickDMX transmitter to a DMX output on a console or interface using a standard DMX cable. Power the transmitter according to the manufacturer's instructions and ensure the unit's indicators show it is operational. Pair the transmitter with a compatible QuickDMX receiver by following the pairing procedure provided with the receiver: typically this involves setting both units into pairing mode and confirming the link via LED feedback. Once paired, address and control fixtures as usual from the console; the transmitter forwards DMX512 data wirelessly to the linked receiver(s).

Recommendations

For reliable operation, install the transmitter with a clear line of sight to the receiver where possible, avoid placing the unit near large metal obstructions or strong RF sources, and verify firmware and receiver compatibility before deployment. Use quality DMX cables for the console connection and verify channel addressing on fixtures after establishing the wireless link.