Eindkap EUROLITE RUBBERLIGHT 50510120 — rubberen eindkap voor verlichtingsarmaturen

The EUROLITE RUBBERLIGHT 50510120 end cap is a rubber protective cap designed for lighting fixtures and accessories. It fits over exposed tube ends and connector housings to provide a simple barrier against dust, moisture and mechanical abrasion. The cap is intended for use in stage, event and studio installations where reliable end protection is required without affecting fixture performance or assembly.

Advantages

The rubber construction offers flexible but durable protection that cushions against impacts and resists tearing during handling. Its close-fit design reduces ingress of dust and light splashes of moisture while remaining easy to install and remove by hand. The cap's low profile does not interfere with mounting brackets or adjacent components and helps extend the service life of exposed ends.

Suitable for

Key specifications

How to use

Before fitting, ensure the fixture end or connector is clean and free of sharp debris. Slide the rubber cap over the exposed end until it seats snugly; no tools are required. To remove, grip the cap and pull it straight off to avoid stretching or tearing. Fit caps to all exposed ends during storage or transport and check periodically during long events to ensure they remain seated.

Recommendations

The cap is designed for protective coverage and not for electrical insulation or sealing under pressure. Avoid prolonged exposure to solvents, extreme heat or direct flame. For outdoor or long-term moisture exposure, consider additional sealing measures. Inspect capped ends regularly and replace the cap if signs of cracking or permanent deformation appear.