Ethernet-patchkabel InLine Cat6 S/FTP PiMF 250MHz PVC, RJ-45–RJ-45, koper, transparant, 15 m

InLine Cat6 S/FTP PiMF patch cable, 15 m in length, provides a shielded copper connection for structured Ethernet networks. The S/FTP shielding combines an overall braided shield with individually foil‑shielded pairs to reduce electromagnetic interference and pair‑to‑pair crosstalk. Terminated with RJ‑45 plugs on both ends and a transparent PVC jacket, this Cat6 cable supports frequencies up to 250 MHz and is suitable for Gigabit Ethernet links in office, home, and data‑cabinet environments.

Advantages

The S/FTP PiMF construction ensures improved protection against external EMI and maintains signal integrity over the full 15 m length. Copper conductors provide reliable electrical conductivity and consistent performance for high‑speed data transmission. The transparent PVC jacket offers mechanical protection while allowing visual inspection of the internal pair structure. Standard RJ‑45 terminations enable plug‑and‑play compatibility with common networking equipment.

Suitable for

• Gigabit Ethernet connections (1000BASE‑T)
• Office and home network installations
• Structured cabling and patch panels
• Environments where EMI reduction is required

Key specifications

• Cable category: Cat6
• Shielding: S/FTP (overall braid + foil‑shielded pairs)
• Conductor material: copper
• Connector type: RJ‑45 to RJ‑45
• Frequency support: up to 250 MHz
• Jacket material and finish: PVC, transparent
• Length: 15 m

How to use

Connect one RJ‑45 plug to the network device (switch, router, modem, or network interface) and the other plug to the destination device or patch panel. Ensure connectors are fully inserted and the latch engages. Route the cable to avoid tight bends and sources of strong electromagnetic fields; maintain reasonable separation from power lines and large motors. If installed in cabinets or racks, secure the cable with appropriate cable management to prevent strain on the connectors.

Recommendations

For optimal performance, use the cable within its specified 15 m length and avoid repeated sharp bends or kinking. In environments with significant EMI, verify shield continuity through grounded patch panels or shielded connectors. Clean connectors before insertion if dust is present and replace the cable if any outer jacket damage or connector deformation is observed.