Geheugen G.SKILL Ripjaws F4-2400C16S-16GRS (DDR4 SO-DIMM; 1 x 16 GB; 2400 MHz; CL16)

G.Skill Ripjaws DDR4 SO-DIMM 16GB (2400 MHz, CL16, 260-pin) is a laptop memory module designed to upgrade small form factor PCs and notebooks. This DDR4 SO-DIMM operates at 1.2V and provides improved data transfer rate and energy efficiency compared with previous generations. The module is hand-screened during production and backed by a limited lifetime warranty for long-term reliability.

Advantages

The Ripjaws DDR4 SO-DIMM offers automatic overclocking on compatible systems, allowing the module to be detected and run at its rated 2400 MHz without BIOS adjustments. Built from specially screened components, it aims to deliver stable performance and reduced power consumption thanks to its 1.2V design, which lowers heat output and helps systems run cooler and more efficiently.

Suitable for

• Upgrading laptop memory to 16 GB for better multitasking
• Small form factor or mini-PCs that accept 260-pin DDR4 SO-DIMM modules
• Systems using 6th Gen Intel® Core™ processors and other compatible DDR4 platforms

Key specifications

• Capacity: 16 GB
• Type: DDR4 SO-DIMM (260-pin)
• Memory speed: 2400 MHz (rated)
• CAS Latency: CL16
• Voltage: 1.2 V
• Manufacturer MPN: F4-2400C16S-16GRS
• EAN: 4719692007674

How to use

Power off the laptop or small form factor PC and disconnect the power source before installation. Open the memory access panel according to the device manufacturer’s instructions, remove any existing SO-DIMM if required, and align the module with the 260-pin slot. Insert the module at a slight angle and press down until the retention clips engage. Reassemble the device and power it on. On compatible systems, the module’s auto-overclocking profile will be detected and the memory will run at the rated 2400 MHz without manual BIOS changes.

Recommendations

Use this G.Skill Ripjaws DDR4 16GB SO-DIMM as a direct replacement or addition to existing laptop memory when the system supports DDR4 260-pin SO-DIMM modules. Verify motherboard or laptop compatibility (including support for 2400 MHz profiles and maximum supported memory) before purchase. Keep the device powered off and grounded while installing to avoid electrostatic damage.