Geheugen Mushkin Redline DDR4 16 GB 3200 MHz

The Mushkin Redline DDR4 16GB 3200MHz is a single-module UDIMM designed to deliver reliable high-performance system memory. With a 3200 MHz memory clock speed, CAS latency of 22 and 1.2 V operating voltage, this module is intended for desktop platforms that support DDR4 UDIMM. The module features a Lumina™ RGB heatsink and has been hand-tested to ensure quality when installed correctly.

Advantages

Enhanced timings and enhanced frequency settings are programmed to provide improved performance and to run at the ideal frequency for compatible systems when the memory is correctly installed. Hand-tested manufacturing helps ensure consistent quality, while the Lumina™ RGB heatsink supports heat dissipation and offers customizable lighting. The module’s 16 GB capacity and DDR4 design make it suitable for both gaming and professional use cases that require fast memory bandwidth.

Suitable for

• Upgrading a desktop PC to increase available RAM
• Gaming systems that support DDR4 UDIMM modules
• Workstations and content-creation rigs needing higher memory capacity and speed

Key specifications

• Brand: MUSHKIN
• Model: Redline DDR4
• Capacity: 16 GB (single module)
• Type: DDR4 UDIMM
• Memory clock speed: 3200 MHz
• CAS latency: 22
• Voltage: 1.2 V
• MPN: MRE4U320NNNF16G
• EAN: 0846651034007

How to use

Power down the desktop and disconnect it from mains power. Open the case according to the manufacturer’s instructions, locate an available DDR4 UDIMM slot, and align the module with the slot notch. Insert the module firmly until the retention clips snap into place. Reassemble the case, reconnect power and peripherals, then enter the system BIOS/UEFI to verify that the memory is detected and running at the expected frequency or XMP/optimized profile if supported.

Recommendations

Install the module in matched pairs where supported by the motherboard to enable dual-channel operation. Ensure BIOS/UEFI settings are configured for the intended frequency and timings; if stability issues occur, try manually adjusting voltage or timings as per motherboard guidance.