Glasvezel-transceivermodule BlueOptics AA1419077-E6-BO 1250 Mbit/s SFP

The BlueOptics AA1419077-E6-BO is a fiber optic transceiver module in SFP form factor designed for single-port network devices and optical links. With a maximum data transfer rate of 1250 Mbit/s and a compact silver metal housing weighing 20 g, this unit provides standard-compliant optical connectivity for switches, routers and media converters that accept SFP modules. The module's small form factor and industry-standard interface simplify installation into compatible SFP slots while maintaining stable optical transmission for short- and mid-range fiber links.

Advantages

This SFP transceiver offers a standardized SFP interface for broad compatibility with network equipment, supporting a maximum data rate of 1250 Mbit/s for reliable optical links. The compact silver metal housing provides robust mechanical protection and helps dissipate heat, while the low weight supports easy handling and installation. The module is suitable for replacing or expanding optical ports in managed and unmanaged networking hardware that supports SFP optical modules.

Suitable for

• Upgrading or expanding SFP ports in Ethernet switches and routers
• Connecting fiber links between network devices in data closets and server rooms
• Integrating into media converters to convert electrical to optical signals
• Use in enterprise and carrier access networks that require 1.25 Gbps optical links

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Product colour: Silver metal housing
• Weight: 0.02 kg (approx. 20 g)

How to use

Power down or follow hot-swap guidelines of your network device, then insert the SFP transceiver into an empty SFP slot until it clicks into place. Connect the appropriate LC fiber cable or patch cord to the optical port, ensuring correct fiber type and polarity. Restore device power if required and verify link status through the host device's interface or indicator LEDs. If necessary, configure the device's port settings to match the optical link speed and duplex requirements supported by the transceiver.

Recommendations

Use compatible single-mode or multimode fiber cables as specified by your network equipment and verify connector type (commonly LC). Observe electrostatic discharge precautions when handling the module and keep optical connectors clean to maintain signal quality. Refer to the host device documentation for supported SFP modules and any required firmware or configuration steps.