Glasvezel-transceivermodule BlueOptics AT-SP10BD20-12-BO 10000 Mbit/s SFP+

The BlueOptics AT-SP10BD20-12-BO is a fiber optic SFP+ transceiver module designed for 10 Gigabit Ethernet and other high-speed optical applications. It supports a maximum data transfer rate of 10000 Mbit/s and uses a single-mode fiber interface with an LC simplex connector. The module is silver in colour, lightweight at approximately 0.02 kg, and conforms to CE, FCC and RoHS standards.

Advantages

This SFP+ transceiver provides a standardized MSA-compliant form factor for use in compatible switches, routers and storage hardware. It supports high-speed data transmission over single-mode fiber and is designed for stable, long-term operation. The compact, lightweight metal housing facilitates dense installations and helps with heat dissipation, while conformity to common regulatory standards ensures basic electromagnetic and material compliance.

Suitable for

Key specifications

How to use

Install the module into an SFP+ slot on compatible networking equipment until it latches, then connect an LC simplex single-mode fiber patch cable to the module. Ensure the fiber polarity and connector orientation are correct and that the remote port is configured for 10G operation. Check link status through the host device interface; if available, enable or read digital diagnostic monitoring (DDM/DOM) functions in the host to monitor parameters such as optical power and temperature. Always follow your hardware vendor's insertion and ESD handling procedures when installing or removing transceivers.

Recommendations

Use high-quality single-mode LC patch cords and maintain clean connector endfaces to ensure low-loss connections. Verify that your network hardware supports SFP+ MSA modules and the appropriate wavelengths and link distances before deployment. When possible, enable DDM/DOM in the host device to assist with remote monitoring and troubleshooting.