Glasvezel-transceivermodule BlueOptics AT-XPSR-BO XFP LC aluminium

The BlueOptics AT-XPSR-BO XFP LC Aluminium is a fiber optic transceiver module designed for 10G multimode short-range networks. It uses an XFP interface with an LC duplex connector and is housed in an aluminium casing. The module is lightweight (20 g) and intended for installation in compatible network hardware that supports XFP transceivers.

Advantages

The module follows MSA-compatible XFP form-factor standards and provides an LC duplex connection for simultaneous transmit and receive over multimode fiber. The aluminium housing offers mechanical durability while keeping the module lightweight. Designed for interoperability, it is suitable for use in devices that accept XFP transceivers and supports common short-range optical networking scenarios.

Suitable for

Key specifications

How to use

Install the BlueOptics AT-XPSR-BO into an available XFP slot on compatible network equipment following the host vendor's hot-swap and insertion guidance. Connect LC duplex multimode fiber patch cords to the module's LC ports, ensuring correct Tx/Rx alignment. Verify link status using the host device's port indicators and management interface. If supported by the host, enable or read digital diagnostic monitoring (DDM/DOM) functions to observe real-time parameters such as optical power and temperature.

Recommendations

Use high-quality multimode LC patch cords and ensure clean connector endfaces to maintain optimal link performance. Confirm compatibility with the host device's XFP slot and software requirements before deployment. Handle the module by its edges and store unused transceivers in antistatic packaging.