Glasvezel-transceivermodule BlueOptics JQ432A-BO 10000 Mbit/s SFP+ 1310 nm

The BlueOptics JQ432A-BO 10000 Mbit/s SFP+ 1310 nm is a fiber optic transceiver module designed for high-speed single‑mode optical links. It supports data rates up to 10 Gbit/s and operates at a wavelength of 1310 nm. The module follows SFP+ and MSA form-factor standards, uses an LC duplex connector for transmit and receive channels, and has a compact, lightweight metal housing that is RoHS compliant. Its specified reliability and MTBF make it suitable for installation in enterprise network equipment that accepts compatible 10GBASE‑LR SFP+ modules.

Advantages

The module delivers 10 Gbit/s performance over single‑mode fiber and is compatible with common SFP+ ports that accept 10GBASE‑LR optics. The compact SFP+ form factor and LC duplex interface enable easy insertion into switches, routers and other network devices. Built and tested to MSA mechanical and electrical standards, the transceiver offers diagnostic capabilities via DDM/DOM when supported by host hardware, allowing remote monitoring of supply voltage, laser bias current, transmit power, receive power and temperature. Its lightweight metal housing and RoHS compliance reduce environmental impact and ensure straightforward handling and installation.

Suitable for

• 10 Gbit/s Ethernet links in data centers and enterprise networks
• Long‑reach single‑mode fiber connections up to several kilometers
• Interconnects between switches, routers and storage systems
• High‑speed applications requiring SFP+ 10GBASE‑LR compatible optics

Key specifications

• Interface type: SFP+ (MSA compliant)
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1310 nm
• Connector: LC duplex
• Compatibility: 10GBASE‑LR class optical transceiver for single‑mode fiber
• Housing: Metal, silver color, compact SFP+ form factor
• Weight: 0.02 kg
• Environmental: RoHS compliant
• Diagnostic: Digital Diagnostics Monitoring (DDM/DOM) support when host supports SFF‑8472

How to use

Insert the BlueOptics JQ432A-BO transceiver into an available SFP+ port on a compatible switch, router or host adapter until it clicks into place. Connect LC duplex single‑mode fiber patch cords following correct polarity (Tx to Rx). Ensure the host device supports 10GBASE‑LR optics and, if DDM/DOM monitoring is required, that the host firmware exposes the diagnostic interface. After installation, verify link status and data rate on the host device and monitor optical parameters through the management interface as needed.

Recommendations

Use high-quality single‑mode LC patch cords and maintain clean connector endfaces to ensure optimum signal quality. Verify device compatibility and enable DDM/DOM monitoring in the host system for remote diagnostics. Follow manufacturer guidelines for ESD protection during handling and install transceivers in powered-down or hot-swap supported equipment according to the host device instructions.