Glasvezel-transceivermodule BlueOptics XCVR-010M31 1250 Mbit/s SFP 1310 nm

The BlueOptics XCVR-010M31 1250 Mbit/s SFP 1310 nm is a single-port fiber optic transceiver module designed for use in standard SFP slots. Operating at a wavelength of 1310 nm and supporting a maximum data transfer rate of 1250 Mbit/s, this module provides a compact, hot-pluggable solution for point-to-point fiber connections and network uplinks. It is compatible with equipment that accepts SFP form-factor modules and is intended for reliable short- to medium-range optical transmission.

Advantages

The module offers a compact SFP form factor that supports easy installation and replacement without powering down the host system. With a 1310 nm wavelength and support for up to 1250 Mbit/s, it suits common fiber network infrastructures and provides stable optical transmission. The design emphasizes interoperability with standard SFP interfaces and minimal configuration requirements, making it suitable for diverse networking hardware.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP transceiver into a compatible SFP slot on your switch, router, or media converter until it latches. Connect the appropriate fiber optic cable to the module’s LC or compatible connector, ensuring correct polarity for TX and RX. After physical installation, verify link status and data rate through the host device interface or network management system. No special software is required for basic operation, though some platforms may display transceiver information in system diagnostics.

Recommendations

Handle the transceiver by its housing and avoid touching the optical connector end-face. Use dust caps when the module is not connected and keep fiber connectors clean to maintain signal integrity. Match the transceiver wavelength and fiber type to your network design, and verify compatibility with the host device’s SFP interface before installation.