Glasvezeltransceivermodule BlueOptics MP-S311X2-NCL10-BO SFP+ LC aluminium 20 g

The BlueOptics MP-S311X2-NCL10-BO is a 10G SFP+ fiber optic transceiver module designed for single-mode links with an LC duplex connector. Constructed in an aluminium housing and weighing approximately 20 g, this module supports 10GBASE-LR optical transmission over single-mode fiber up to typical long-reach distances. It implements separate 1310 nm transmitter and receiver paths and follows MSA pinout and mechanical dimensions for SFP+ form-factor interoperability with compatible network equipment.

Advantages

This SFP+ transceiver offers high-speed 10 Gbit/s data transfer in a compact, lightweight aluminium enclosure that helps with thermal dissipation. Compliance with industry MSA standards ensures mechanical and electrical compatibility with a wide range of switches, routers and storage systems that accept SFP+ LR optics. The transceiver supports Digital Diagnostics Monitoring (DDM/DOM) when the host hardware provides support, enabling real-time monitoring of supply voltage, laser bias current, transmit optical power, receive optical power and temperature for easier remote troubleshooting.

Suitable for

Key specifications

How to use

Install the transceiver into any compatible SFP+ slot following the host device manufacturer’s hot-plug instructions. Use LC duplex single-mode patch cables to connect the module to the remote transceiver or patch panel, ensuring correct TX-to-RX fiber pairing. Confirm link configuration and supported protocols on the host device (Ethernet, Fibre Channel over Ethernet or other supported protocols) and verify that DDM/DOM is enabled in the management interface if diagnostic monitoring is required. Avoid touching the optical interfaces and keep dust caps on when the transceiver is not in use.

Recommendations

For reliable long-reach performance, use quality single-mode LC patch cords and proper fiber management (patch panels, strain relief). Verify the host device firmware and compatibility list for SFP+ LR optics and check DDM/DOM availability if remote diagnostics are required. Store and handle the transceiver in ESD-safe conditions and keep optical connectors clean to maintain optimal signal quality.