InLine stroomkabel, Israël type H / 3-polig IEC C13 stekker, 3 m

InLine power cable Type H to IEC C13, 3 m length and 10 A rating, is intended to connect equipment with a standard IEC C14 inlet to Israeli mains outlets featuring the three‑pin Type H plug. The cable provides a grounded connection and is suited for desktop PCs, monitors, printers and other IT devices that require a C13 power lead. The angled Type H plug and straight IEC C13 coupler are delivered in a black finish and support safe mains connection in environments with Type H sockets.

Advantages

The cable combines a three‑pin grounded Type H mains plug with a straight IEC C13 female connector, allowing direct connection of appliances with an IEC inlet without adapters. With a 3 m length it offers extended reach from wall outlets to equipment racks or desks. The 10 A current rating and conductor construction are suitable for typical office and home IT devices, providing a reliable power path while minimizing the need for additional extension leads.

Suitable for

• Desktop computers and workstations with IEC C14 inlets
• Monitors and display units that accept C13 power leads
• Laser and inkjet printers, scanners and multifunction devices
• Network equipment such as switches, routers and small UPS units with C14 sockets
• Laboratory and measurement instruments using standard IEC power connections

Key specifications

• Plug type: Israel Type H angled male (3‑pin)
• Coupler type: IEC C13 straight female
• Cable length: 3 m
• Maximum current: 10 A
• Conductor cross-section: 0.75 mm² (specified cable conductor)
• Connector angle: 90° at plug end
• Colour: Black

How to use

Ensure the device is switched off before connecting the power cable. Insert the Type H plug securely into a compatible Israeli mains outlet and connect the IEC C13 coupler to the appliance's IEC C14 inlet until it seats firmly. Verify that the cable is routed to avoid strain or sharp bends at the connectors and that it does not obstruct walkways. After connection, switch on the mains supply and then the device following the manufacturer's power‑up procedure.

Recommendations

Use this InLine Type H to IEC C13 cable for devices whose combined current draw does not exceed 10 A. Avoid using the cable with high‑power appliances that require higher current ratings. Inspect the cable periodically for damage to the insulation or connectors and replace it if any wear or deformation is found.