Installatieautomaat Legrand 411966 breedte 78 mm diepte 101 mm hoogte 89 mm

The Legrand 411966 circuit breaker is designed to protect electrical circuits by interrupting current flow in overloads or short circuits. With a compact housing measuring 78 mm wide, 101 mm deep and 89 mm high, it is suitable for installation in distribution boards where space is limited. The device is intended for residential and commercial electrical systems and provides reliable protection to reduce the risk of wiring damage and electrical hazards.

Advantages

The compact dimensions allow installation in panels with limited space while maintaining standard mounting compatibility. The breaker is engineered for consistent tripping performance and repeatability under fault conditions, helping to prevent damage to connected equipment. Its robust construction supports long-term operation in typical indoor electrical environments and simplifies replacement or upgrading of existing circuit protection.

Suitable for

Key specifications

How to use

Install the circuit breaker into the distribution board following local electrical codes and the panel manufacturer’s instructions. Ensure power is disconnected before fitting the device. Connect the supply and load conductors to the designated terminals, verify tight and secure connections, and restore power to test correct operation. After installation, verify that the breaker trips under test conditions appropriate for the circuit and that there are no abnormal noises or heating during normal operation.

Recommendations

Specify the breaker rating and characteristics required for the protected circuit prior to installation, and use a qualified electrician to perform mounting and connection. Periodically inspect connections and the device for signs of wear, corrosion or overheating, and replace the breaker if tripping becomes irregular or if physical damage is observed.