Koper-transceivermodule BlueOptics 02-SSC-1874 10000 Mbit/s SFP+

The BlueOptics 02-SSC-1874 is a copper SFP+ transceiver module designed for reliable high-speed connectivity. Supporting a maximum data transfer rate of 10000 Mbit/s, this compact module fits standard SFP+ ports and connects network devices over copper cabling. It is intended for use where short-range, cost-effective 10GbE links are required and integrates with switches, routers and servers that accept SFP+ copper modules.

Advantages

This SFP+ transceiver delivers stable 10 Gbit/s performance over copper media with low latency and straightforward plug-and-play installation. Its compact SFP+ form factor conserves port density while providing predictable electrical interface characteristics. The module supports standard SFP+ connectivity requirements, making it compatible with many enterprise and datacenter networking devices that accept copper SFP+ modules.

Suitable for

• Short-range 10 Gigabit Ethernet links between switches and servers
• Upgrading existing copper-based network infrastructure to 10GbE
• Edge and access layer connections in enterprise networks
• Test labs and temporary high-speed links requiring easy removal and replacement

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Media: copper cabling (compatible with appropriate SFP+ DAC or copper link)
• Form factor: SFP+ hot-pluggable transceiver
• Typical use range: short-distance 10GbE connections (dependent on cable and host hardware)

How to use

Insert the BlueOptics SFP+ module into an SFP+ port on a compatible switch, router or server until it latches. Connect the appropriate copper cable or direct-attach copper assembly to the module. Ensure the host device supports copper SFP+ modules and configure the network interface as required by your operating system or switch firmware. For removal, unmount the link in software if needed, release the latch and pull the module straight out to avoid damaging the slot.

Recommendations

Use certified copper cables and verify host compatibility before deployment; consult device documentation for supported module lists and any required firmware settings to ensure optimal 10GbE performance and link stability.