Koper-transceivermodule BlueOptics MA-SFP-1GB-TX-CS-BO 1,25 Mbit/s

The Copper Transceiver Module BlueOptics MA-SFP-1GB-TX-CS-BO 1.25 Mbit/s is a compact SFP copper transceiver designed for 1000BASE-T network links. It provides a standardized SFP interface in a grey housing and supports a maximum data transfer rate of 1.25 Mbit/s while weighing approximately 20 g. The module is intended for use in network equipment that accepts SFP copper transceivers and requires reliable wired Ethernet connectivity over twisted-pair cabling.

Advantages

This BlueOptics SFP module follows SFP mechanical and electrical standards and is compatible with systems that support standard 1000BASE-T SFP copper transceivers. Its compact SFP form factor allows easy hot-plug installation in switches, routers and other compatible network devices. The module’s grey housing and lightweight construction make it suitable for dense installations where space and weight are considerations. By providing a copper RJ45 interface in an SFP package, it enables straightforward connection to existing Ethernet cabling infrastructure.

Suitable for

Key specifications

How to use

Power off or follow hot-swap procedures as specified by your network device manufacturer, then insert the SFP transceiver into an available SFP slot until it clicks into place. Connect a standard copper Ethernet cable (Cat5e or Cat6 recommended for gigabit performance) to the RJ45 port on the transceiver and to the remote device. Ensure the host device supports 1000BASE-T SFP copper modules and, if required, enable or verify link settings in the device firmware or management interface. Monitor link status LEDs or management diagnostics to confirm successful link negotiation at the expected data rate.

Recommendations

Use quality twisted-pair cabling (Cat5e or higher) for reliable gigabit performance and keep cable runs within standard copper Ethernet distance limits. Verify compatibility with the target hardware and firmware; if the host reports link or compatibility issues, check for firmware updates or consult technical support before installation. For installations requiring diagnostic monitoring, confirm that the host supports any available digital diagnostic functions for SFP modules.