LED-strip-ontvanger EUROLITE 50531155 voor RGB-, CW- en WW-LED-systemen, stuurmodule

The EUROLITE 50531155 LED strip receiver is a compact controller module designed to manage RGB, cold white (CW) and warm white (WW) LED strip configurations. It acts as an interface between a remote control or a central control system and the LED strip, allowing switching of outputs and selection of color and white-balance settings. The module is intended for installation in lighting setups that require separate control of RGB channels and white channels for combined decorative and functional illumination.

Advantages

This receiver supports independent control of RGB channels alongside cold and warm white channels, enabling mixed-color and tunable white lighting from a single strip. Its compact design allows hidden mounting within fixtures or recessed cavities. The unit provides straightforward signal reception and output switching, simplifying integration with remote controls or compatible control systems. The device is engineered for stable operation with LED strip loads and offers consistent color mixing and white-balance adjustment when used within specified operating conditions.

Suitable for

Key specifications

How to use

Install the receiver in a dry, well-ventilated location near the LED strip and the control source. Connect the LED strip’s RGB and white wiring to the corresponding outputs on the module, and connect the control input to the remote receiver or control system according to the control equipment instructions. After wiring, apply power and use the compatible remote or control interface to switch outputs, adjust color mixing, and change warm/cool white balance. Ensure polarity and wiring continuity before powering the system to avoid damage to LEDs or the receiver.

Recommendations

Use this receiver with LED strips and power supplies that match the module’s electrical requirements, and install within an enclosure if exposed to dust or mechanical stress. For reliable color mixing and tunable white performance, keep cable runs short and follow manufacturer guidelines for maximum load per channel.